Microwave motion sensor MMS
Microwave motion sensor MMS
Up to 4 sensors can be used together with the GC 800 luminaire group controller. Synchronous switching of the group of luminaires connected to the controller in full brightness mode will take place when at least one of the sensors is triggered. Up to 4 sensors are connected in series to the discontinuities of the single wire loop connected to the controller. The number of lights connected to the output of the controller on a two-wire power line can be up to 20 pieces. The controller can also be used to switch any load up to 800VA.
Together with the LED strip controller SC
In combination with the NC 300 mains load controller, it is possible to control light devices with a power consumption of up to 300W. Switching takes place without interference, when the AC mains voltage goes over 0.
Overall dimension, mm |
40×23×8 |
Power supply voltage, V |
8-24 |
Current Consumed, mA |
4 |
Maximum output current "open drain" mA |
1000 |
Maximum current of the logic level output, mA |
1 |
Turn off delay time |
40-60 seconds on request from 10 to 300 seconds |
Warranty |
5 years |
Name |
Supply voltage |
Dimensions, mm |
Complete set |
Price including VAT |
MMS 12-24 |
8-24V |
40×23×8 |
- |
|
MMS 230 |
230V (AC) |
- |
With the power section |
- |
MMS 230-1 |
230V (AC) |
- |
In the case |
- |